Good afternoon! Do not buy their equipment, it simply does not work without serious improvements. We bought the head of the TYO 60 cp sugar production line to replace the same of our old line. we just requested a matrix for 2 cubes. As a result, they delayed the production of the line for 2 months. The line came unstaffed (there were no punches). The matrix was not made correctly, the location of the cube is not correct, and therefore the cube simply cannot be assembled. The frame is made shorter by 10 cm, the tape moves faster than necessary, the mesh moves slower than it should. the tape on which the cube is thrown off is narrow, the cube colliders are not installed, the shaft of the main gearbox is short, they made an extension that constantly turns away (you can't put a grover there, since there is a narrow opening and a thread for the screw fastening the eccentric cover. The eccentric is not made correctly, its fastening bolt is made short and it is twisted to the limit and the eccentric is pressed against the punches. mixers are also not made correctly, they are also twisted and pressed against the walls of the case. All belt drive rollers are without bumpers. There is no electrical circuit. In general, I recommend ordering from other manufacturers, and if you ordered from these figures, then be sure to sign the commissioning agreement and go to Ankara yourself and accept the line there so that they will definitely demonstrate the operation of the line.