I brought them to change the tire to the kugoo m5 pro wheel motor, as a result, the entire engine was scratched, and it's okay where the rim is, but how could the back cover be scratched... When I took it away, there was dirt on the engine cover, which was definitely not there at the time of the wheel delivery, in general, I did not attach much importance then, but at home when I wiped it I noticed that the lid was all in deep scratches, I started calling there to find out what happened to my wheel, to which the master replied to me "You want the scooter always remained new? touch up with a marker, we are doing tire fitting on the machine, and it turns the wheel, so it scratches" So, as your client, I don't care what you have there with the machine, these are your problems, if you have such a machine, then warn people that they will get scratches at the exit, and yes, I keep an eye on my scooter and do everything possible so that it retains the condition of the new one as long as possible, so and I came to you so that they put a tire on me NORMALLY, I gave 60 rubles for this, but as a result I got a low-quality job, it would be better to sit at home with screwdrivers for an extra hour, it would be more accurate... To sum up, scooters in this office are treated haphazardly, I will not carry anything else there and I do not advise you, but if you still decide, then be sure to take a close-up detail before entering, as an evidence base, and when you take it away, inspect everything in their place, see the dirt that was not there, wipe and look what's underneath it. I hope this review will help you with choosing a workshop for your scooter
We put a cast tire on the motor wheel on a scooter and the problem of punctures was solved!
The tire was picked up by a non-native (not for the model), but the master did a great job!
Kugo g2 pro scooter, replacement of the tire of the rear motor wheel and replacement of the rear pads.
105 rubles for everything (not cheap!).
And tin!!! during assembly, the rear lever was not put on the square suspension bolt, in fact, the lever remained hanging in the air. What would happen during operation is scary to think about...
When I picked up the scooter, I drew the attention of the master that the decorative overlay on the back was crooked, they said everything was normal, that's how it should be.
But this curvature gave me no peace...at home, when I took it off and unscrewed the bolt, I saw a tin, see the photo
I don't understand how this can be done, it's just sabotage.
I do not recommend this service